Machine Placement in Workshops

Designs can be shown in general in new systems or workshops to be revised.  We can summarize these general design topics.

  Machine and section layout should not be done in accordance with the work order.  This line-up will not only prevent labor, but also support selection and job assignment.

  For occupational hygiene, sufficient parts should be created for preparation sections such as polishing, process and cutting.  While designing the departments, interventions such as light and removal from school are important.

  For the protection of all machines and machines against what must be done, must be done.

  The electrical cables coming to the machines and benches should be designed in such a way that they are exposed and prevented.

  For 30 road traffic accidents and accidents on the boards.  In front of the panel, the main break switch is important for the insulating containers and outside the panel.

  Operating instructions and necessary warning signs next to machines and benches.

  In workshops, light and air treatment should be suitable for work.

  There should be emergency buttons on the machines and they should be hung in places where they can be called in an emergency.

  The ground is slippery and the roads can be scratched from the roads.

  Doors must be chosen correctly.

  Dressing rooms, lockers and showers for employees.

  Sound and light alarm device for the gases used.

  For cylinders, they can be separated from combustible and combustible purchases and will be taken full.

  A separate room for the compressor and presumable containers.

  The width of the stairs should be at least 110 cm, the railings should be at least 90 cm and the distance between the benches should be at least 80 cm.